Introduction of CAMOZZI Sensitive Computer Control Valve and Kangmaosheng Sensitive Computer Control Valve

Authentic CAMOZZI Sensitive Computer Control Valve, Kangmaosheng Sensitive Computer Control Valve

Work pressure = 4_10 bar

Nominal flow = 700 Nl/min

Driving Force = 2N (under 6 bar working pressure)

Series 3 and 4 sensitive computer-controlled valves are a new type of computer-controlled valves with pilot structure. They are often used as position switches in large flow and small driving force applications.

Series 3 is a pressure relief control mode, and steel extension lever is installed on the valve to increase its sensitivity, driving force is very small, about 2N.

Series 4 is a pressurized control mode, and its driving force is greater than Series 3.

Series 1 and 3 computer-controlled valves have two three-way and two five-way functions. They have three driving modes: cylindrical shaft drive, ball lever drive and one-way ball lever drive. The reset form is mechanical spring reset.

Authentic CAMOZZI Sensitive Computer Control Valve, Kangmaosheng Sensitive Computer Control Valve

For three series of two-position three-way monostable computer-controlled valves, when feeding pressure to one port, its function is normally closed (NC); when feeding pressure to three ports, its function is normally open (NO). Two ports are always working ports.

Series 2 small computer-controlled valves are two-position three-way valves with normal closing (NC) and normal opening (NO) functions. The valve body is equipped with M5 internal threaded joint or? 4 fast plug joint.

Structural sliding valve type (pilot control)

Valve position function: two-position three-way, two-position five-way

Material aluminium body, stainless steel sliding spool, NBR seals

Interface G1/8 - G1/4

Ambient temperature 0_60 degree C

Medium temperature 0_50 degree C

The working pressure is shown in the technical parameters of the relevant models.

The compressed air filtered by the medium does not need oil mist lubrication.

If oil mist lubrication is used, oil mist lubrication should be used uninterruptedly (ISO VG32 lubricant is recommended)