Industry new

Brief introduction of inert gas for rapid joint

15 stainless steel live joints such as shock and impact machines will reduce durability.

Stainless steel pipe fittings quick connector is a connector that can connect or disconnect the pipe without tools. Fast joint can be divided into quick joint of air, fast joint for oxygen fuel gas, rapid joint of gas liquid, fast joint for oil pressure, quick joint for inert gas, quick joint for cooling water temperature oil, fast joint of semiconductor.

The stainless steel quick connector can be kept at 1.310? Pa vacuum degree when it is in separate condition. Caution: inert gas fast connector is suitable for vacuum piping and compression test. Sleeve and plug have built-in automatic switch valve suitable for vacuum.

1 stainless steel fittings should not exceed the maximum operating pressure limit.

Stainless steel ball valve multiway valve manufacturers fast connector manufacturers to prevent the formation of sealing material wear or leakage. 2 do not apply it outside the range of temperature.

3 do not stop artificially striking, bending, stretching, and preventing breakage.

4 do not stop joining in a pressurized or residual pressure state.

5 please do not stop dismantling

6 please use the sealing material for the outer thread of the control thread.

7 do not stop artificially striking, bending, stretching, and preventing breakage.

8 please do not use fluid other than fluid.

9 please do not use the use of the quick joint.

10 do not connect to the fast fluid connector produced by other companies. Prevent the formation of bad work or leak.
11 do not mix in metal powder or sand and other central use.

12 if it is attached to the sundries, there will be a bad job or a leak.

13 the brake valve must be set before the quick joint.

14 please do not use it as a hinge joint.

PREVIOUS：Attention to the selection of quick jointNEXT：Application field fast joint