Industry new

Rubber joints lack of glue can do this

The lack of rubber in rubber joints is due to the fact that the rubber is not full of colloids. The cause and solution of one of the phenomena is as follows:
The amount of glue used is too small: the amount of glue used is added and the glue hole is notched to ensure sufficient injection of glue;
Spill outlet too large: change the size of the overflow port, reduce the number of overflow outlets, and select the appropriate outlet location;
Too much amount of release product: reduce the amount of release product and ensure that the release product does not stain before use;
Rubber vulcanization speed: adjust the compound formula and extend the scorch time;
The inlet design of the die is unreasonable: it is necessary to improve or replace the die, increase the size of the inlet, increase the number of inlets, etc.;
The material is too hard: Improve the fluidity of the compound.

PREVIOUS：How to avoid tearing and pulling rubber produNEXT：How to deal with rubber products thin skin bu