News

What should you watch out for when using a sewage flow meter? - Focus on Microfluidic Control Technology

We usually use the sewage flow meter when it is correct, and to a large extent, it also affects the accuracy and stability of the sewage flow meter. Below we may wish to look together to see what should pay attention to when using the sewage flow meter?

1. When using a sewage flow meter, it should be ensured that the liquid to be measured is free of impurities, such as no fiber or particulate matter inside.

2. When the sensor starts to work, the sensor should be slowly filled with liquid. Then the valve at the outlet is opened. The sensor cannot work without liquid, and it cannot allow the liquid to pass through and cause impact.

3. Sensors should be inspected and repaired every 6 months. During inspections, care must be taken to avoid damage to the measuring parts inside the sewage meter, especially the impeller. When installing, it is also necessary to look at the position of the guide and the impeller.

4. When the sensor is not working, the internal liquid can be cleaned, and a protective cover can be installed on both sides of the sensor, so as to prevent dust or other debris from entering, and be stored in a dry place.

5, the filter should be regularly cleaned, if not used, but also to clean the liquid inside, like the sensor, but also use the boot, placed in a dry place.

6. Before installing the sewage flowmeter, first connect the display instrument and the wave of the wave device and connect the power supply. You can use the mouth to blow the impeller to see if it can rotate normally, and then install the sensor after the display appears. If it doesn't show up, check to see where the problem is.

PREVIOUS：Considerations when using electromagnetic floNEXT：Application of Quantitative Control Devices -