Industry new

The need to pay attention to the installation of mass flow controller flowmeter

How do you install mass flowmeters? The phenomenon of the purchase of the manufacturers will be delivered on-site package installation, then the installation of mass flowmeters require you to clear it? The following mass flow controller Xiaobian to talk about for you;
First, when installing the equipment, try to avoid installing in a place where there is vibration, and you need to do a solid support when installing. If you must install in the place of vibration source, Xiaobian recommends that you use a hose to connect.
Second, the need to install the flow control valve is best installed at the device outlet, because the flow control valve is a throttle device.
Third, the equipment must be installed at the entrance and exit valve, and the initial installation requires zero calibration.
Fourth, the installation location of the equipment needs to be far away from the pump outlet, in order to prevent the measurement value from fluctuating due to the distance being too close.
5. It should be noted that the heat-insulating housing or the heat-tracing pipe must not be in direct contact with the sensor housing.
Six, need to determine the direction of the arrow and the flow of fluid is consistent.

PREVIOUS：About the characteristics of carbon dioxide fNEXT：Water and air detection in digital flow switc