Industry new

Reasons why a mass flow meter is prone to failure

Flowmeters are now increasing in volume in industrial production. The mass flowmeter is a meter that can help people make measurements. This instrument must pay attention to its use in the process of use, so that it will not be Some problems occurred in use. So how should the cause be found when hardware problems occur?

1Before using the mass flowmeter, it is necessary to install it well. At this time, it is necessary to do it according to the dark transfer specification. If it cannot guarantee the standardization of the installation, it will lead to zero drift of the flowmeter, which certainly cannot measure well. Even if measured, subsequent data cannot be used. When the connection flange is welded, no signal of the corresponding force can be generated, which also causes interference during the subsequent use. There should be no cables next to the sensor. In that case, the magnetic field generated by the cable will certainly cause some interference with the mass flowmeter.

2 There is a problem with the wiring, which will also affect the normal operation of the mass flowmeter. If the power supply's connection line is connected, an error will cause the display to fail to display. If the AC power is used, the fuse may be easily damaged if the current is unstable. In that case, it will also adversely affect the measurement work.

3 When measuring, if the measured medium is doped with air, then two-phase flow phenomenon will occur. At this time, the transmitter will certainly give the staff an alarm notification. If this situation is more serious, the sensor will automatically stop all work.

If there are some failures in the use of the mass flow meter, basically all of them can be repaired, as long as you understand the cause of the failure of the flow meter before use, only if you know the reasons, can you take appropriate measures to remedy the disease, Can solve the problem of failure.

PREVIOUS：How bad is the water vapor in the gas mass flNEXT：Electromagnetic Flowmeters for Wastewater Flo