Industry new

How to solve two major problems of pneumatic high pressure ball valve

Pneumatic high-pressure ball valve is blocked? Gas source failure? What is this good? No need to hurry, some failures of pneumatic high-pressure ball valve, about Xi Xi Xiaobian help you one by one to solve, please read the following carefully.
Pneumatic high pressure ball valve is blocked?
In many cases, the valve of the ball valve is blocked, resulting in pipeline failure or equipment damage. In fact, there are similar problems with either pneumatic or electric valves. How to solve, Xiao Bian said these points we must remember, very much used:
One is direct cleaning, that is, before the problem occurs, do a good job of cleaning the valve to prevent impurities from mixing, resulting in valve blockage; the other is the external flushing method, similar to the cleaning method, but the liquid is replaced by gas or Steam, even if the valve does not move, can be performed as usual.
If a pipeline filter can be installed in the front of the valve, it is also a good way to prevent jamming, especially the kind of ultra-small flow valve, which is very suitable. In addition, it is also possible to change the structure of the valve, such as switching to a throttling device with a large throttle gap, which can also effectively alleviate such problems.
Pneumatic high pressure ball valve gas failure?
When the pneumatic high pressure ball valve encounters gas source faults during use, what should be done? First, learn how to troubleshoot the problem as soon as possible and find out what the problem is.
Among the many faults in the ball valve, the possibility of such failures is due to moisture. The moisture may cause the various components of the pneumatic valve to rust, causing problems in the operation of the components and thus the gas flow. The key to solving is to exclude water. Methods such as adsorption and dewatering, pressure dehumidification, and freezing and dewatering can effectively improve these problems.
If the mixture of pneumatic high-pressure ball valve is not water but oil, how to deal with it? Clear water According to the above method, to remove oil, you need to use the oil filter, you can also solve the gas source failure.
Another possible reason lies in the invasion of dust, so try to prevent it from entering when starting the high-pressure ball valve. A better method is to install an air filter at the front of the valve, and also to replace or clean the valve frequently to ensure gas quality.

PREVIOUS：How to effectively improve the operating effiNEXT：Which occasion is more suitable to use pneuma