Angle seat valve working principle and instructions for use

In our daily life, we often encounter many items that we can't name, such as the angle seat valve. Most of us hear the word angle seat valve for the first time and don't know that it is used. What to do. But the angle seat valve exists on many of the machines we use and plays a very important role. The angle seat valve maintains flow and saves space. The following small series will introduce you to the angle seat valve on the principle and characteristics of knowledge sharing.

Introduction to angle seat valve:
The angle seat valve maintains the flow rate to save space. It uses a single-acting pneumatic actuator with spring safety to operate the steering angle seat valve. When used, it should be normally open or normally closed. Angle seat valve is widely used for short-time frequent start It has the characteristics of sensitive reaction and accurate action. It is used with solenoid valve and pneumatic control can accurately control the flow of gas and liquid. It can realize the requirements of accurate temperature control and dropping liquid.

Angle seat valve features:
1. With valve open or closed position display.
2. External pneumatic pilot for increased service life and maintenance free.
3. There is a self-adjusting sealing gland between the overflow port and the slider to improve the sealing performance.
4. The valve body angle seat structure can realize large flow rate (especially compared with ordinary stop valve), and the structure is compact and the response is fast.

Angle seat valve installation and maintenance:
1. The pipe must be clean and free from contamination.
2. Install as needed, but it is best to have the actuator facing up. Pay attention to the flow direction.
3. Connect the valve and pay attention to the alignment of the pipe. Remove the actuator only when the user requests it.
4. Shut off fluid and control air supply and reduce pressure in the piping system before opening or servicing the angle valve.

Note for angle seat valve:
1. When this flow direction is selected, the life of the product can be increased.
2. When the working medium is a liquid, select the flow to impact the waterproof hammer.
3. For products with a diameter of Φ15/Φ20/Φ25, the working pressure must be below 0.3MPa.

Angle seat valve principle:
The angle seat valve maintains a flow rate to save space, and it uses a single-acting pneumatic actuator with spring safety to operate the steering angle seat valve. When used, the normally open or normally closed SAV series should be selected from stainless steel casting and polytetrafluoroethylene. It can be used in most gases and liquids. Steam and corrosive applications. It has a heat sink to protect the actuator. Ensure that the angle seat valve has a long life and flexible mounting position. To facilitate the positioning of the pressure interface, the actuator housing rotates 350 degrees for added flexibility. A standard display with an open or closed state is included.