Description of the installation method of mechanical seals

1. Assembly of mechanical seal stationary parts:
a. Insert the anti-rotation pin into the corresponding hole of the sealed end cap;
b. Place the static ring seal on the static ring and install the static ring into the sealed end cap. Pay attention to the anti-rotation pin into the static ring groove. When installing the gland, be careful not to let the static ring touch the shaft - the bolt should be tightened evenly several times.
2. Mechanical seal rotating parts assembly:
The rotating parts of the mechanical seal are assembled one by one onto the shaft in a sequential order. If there is a bushing, the rotating parts of the mechanical seal are assembled to the bushing on the outside, and then the shaft with the mechanical seal rotating part is fitted to the shaft.
3. The end cap is mounted on the sealing body and tightened evenly with screws.
4. It is easy to drive the test. If the plate is not moving or it is difficult, check the assembly size.