Industry new

First, the basic parameters and structural principle of the conductive magnetic valve

The basic parameters of the first conductive magnetic valve:
Body material: 304/316 stainless steel
Use medium: water, air, gas, natural gas, etc., weak acid, weak base, slightly corrosive medium
Principle structure: direct motion diaphragm
Control method: normally closed, normally open
Pressure difference range: 0~1.0Mpa
Nominal pressure: 1.0Mpa
Medium temperature: -5~80°C
Ambient temperature: -5~60°C
Connection method: threaded connection, flange connection
Selection voltage: AC380V, 220V, 110V, 36V, 24V DC220, 110V, 36V, 24V, 12V
The structural principle of the first conductive magnetic valve:
The valve skillfully combines the first conductive magnetic valve, the manual valve and the throttle valve, and the pilot valve receives the electric signal switch to drive the main valve. Adjustment screws A and B adjust the medium viscosity range and main valve switching time and can be compensated after the main valve wears. When the pilot valve needs to be repaired, just tighten the adjusting screw B and the isolating screw C, and then remove it and use the manual screw. The screw can also be used to preset the maximum or minimum flow rate when the solenoid valve is automatically controlled.

PREVIOUS：Electromagnetic valve factory solenoid valve NEXT：Description of the classification of high pre