Industry new

Control valve operation and maintenance of the correct discharge pressure of the water cooling unit

This is by thermoforming the refrigerant from the condenser by adjusting the flow of water. If the water temperature is too cold, the refrigerant discharge pressure is too low, which will cause the evaporator coil to freeze, the suction pressure to be low, the harmful trip, or the poor compressor to return oil.
There are two basic types of valves that are used in our industry. One and two and three way valve configurations. Two ways are when the water is completely shut down and the unit is turned off. Three methods are used to keep the water flowing to the condenser water circuit when the pneumatic ball valve is closed and the condenser coil is closed. These valves are typically mounted on a full column of liquid held in the condenser by the outlet condenser coil.
Checking the operation of the valve and the operation of the unit with a higher discharge pressure is important to check the temperature of the condensate and refrigerant entering and leaving the coil. The pressure of the valve spring can be lowered to allow the valve to open to further increase the water flow. If the water is cold, the refrigerant liquid line is hot, it is possible that the condenser is contaminated and needs to be pickled. This is the diagnostic to verify that the valve is functioning properly. The pneumatic control valve has been caught and stopped moving the valve. The regulating valve has been caught and the movement of the valve is stopped.
It is important to check the bellows during the refrigerant leak test time. They can develop cracks and leaking refrigerants. They can develop cracks and leaking refrigerants. These valves can be retrofitted to replace parts. It is also preferable that the unit of the cycle is verified multiple times by the adjustment valve after the adjustment has been made to the valve. It is also preferable that the unit of the cycle is verified multiple times by the adjustment valve after the adjustment has been made to the valve. This will ensure that the valve has the correct pressure setting and operation is correct.

PREVIOUS：Traditional valve parts various skills and soNEXT：How does the cost of a pneumatic valve come f