How to install a sanitary pneumatic ball valve

How to install a sanitary pneumatic ball valve?
1. Remove the protective cover on both sides of the clamp end and rinse and clean the ball valve body in the fully open state;
2. Before installation, the whole machine test must be carried out according to the specified signal. After passing the test, it can be installed on the line;
3. Flush and remove any remaining impurities in the pipeline before preparing to connect with the pipeline;
4. During installation, do not use the actuator part of the ball valve as a lifting point for lifting to avoid damage to the actuator and accessories;
5. Ball valve This type of valve should be installed in the horizontal or vertical direction of the pipe;
6. The pipe near the installation point of the stainless steel ball valve should not have the phenomenon of drooping or bearing external force. Pipe brackets or supports can be used to eliminate the deviation of the pipeline;
7. After connecting with the pipe, tighten the bolt with the specified torque.