Industry new

Turbine flowmeter sensor maintenance instructions

The turbine flowmeter structure is explosion-proof design, which can display the total flow rate, instantaneous flow rate and flow full percentage. The battery adopts long-lasting lithium battery. The single-function integrated battery life can reach more than 5 years, and the multi-function display battery life is also It can reach more than 12 months. The turbine flow meter can display a large number of flow units, in cubic meters, gallons, liters, standard cubic meters, standard liters, etc., can set fixed pressure, temperature parameters compensate gas, pressure When the temperature parameter does not change much, the flowmeter can be used for fixed compensation integration.

The maintenance of the turbine flowmeter sensor section should pay attention to the following points: Use and adjustment

When using, keep the liquid to be tested clean and free of impurities such as fibers and particles. When the sensor is used, the sensor should be slowly filled with liquid, and then the outlet valve should be opened. It is forbidden to be impacted by high-speed fluid when the sensor is in a liquid-free state. The maintenance period of the sensor is generally half a year. When cleaning and cleaning, please be careful not to damage the parts inside the measuring chamber, especially the impeller. Please be optimistic about the positional relationship between the guide and the impeller during assembly. When the sensor is not in use, the internal liquid should be cleaned, and a protective cover is placed on both ends of the sensor to prevent dust from entering and then stored in a dry place.

When used, the turbine flowmeter and filter should be cleaned regularly. When not in use, the internal liquid should be cleaned. As with the sensor, add a dust jacket and store it in a dry place. The transmission cable of the sensor can be laid overhead or buried (the iron pipe should be placed when buried.) Before the sensor is installed, connect it to the display instrument or oscilloscope, connect the power supply, blow the hand or blow the impeller to make it Quickly rotate to see if there is any display, and then install the sensor when there is a display. If there is no display, check the relevant parts and troubleshoot.

PREVIOUS：Two points to note about the use of electromaNEXT：Some common problems in the application of el