brand information

10093 festo order number DKE-40-PPV-A clamping unit cylinder - Festo

Standard cylinder with clamping unit, cylinder according to DIN ISO 6431 and VDMA standard (except length), when the compressed air is sent to the clamping unit, the clamping force is released, the clamping force should be higher than the maximum allowable pressure of the cylinder piston The thrust generated.
note
This cylinder cannot be used as a safety device
Double acting
- Bore diameter from 40 to 100 mm
- Travel from 10 to 2000 mm
- Adjustable terminal position buffer
- for non-contact position sensing
- Piston rod with external thread
Position sensing or proximity sensor: electronic SM...-1 (contact or non-contact) pneumatic SMPO
Characteristics
- Clamp the piston rod at any position
- When the power is cut off or the gas is cut off, the piston rod can be automatically clamped for safety protection.
- The piston rod can be clamped for a long time even in the case of load changes, pressure fluctuations or system leaks.
Derivative type:
- S3: Acid and corrosion resistant piston rod
- S6: Heat resistant seal, temperature up to 150 ° C
- S8: High corrosion protection
10093 festo order number DKE-40-PPV-A clamping unit cylinder - Festo.png

PREVIOUS：10095 festo order number DKE-63-PPV-A clampinNEXT：10091 festo order number OH-8-GE pressure ind