Turck TURCK pressure sensor installation method description

Generally, the damage of the high-temperature melt pressure sensor is caused by the improper orientation of the device. If the sensor is forcibly placed in a small hole or an irregular hole, the vibration film of the sensor may be impacted. Damage, selection of suitable tool processing device holes, is conducive to control the size of the device hole, in addition, the appropriate device torque is conducive to the formation of an outstanding seal, but if the device torque is too high, it will simply lead to the high temperature melt pressure sensor slippage, To prevent this appearance, it is common to modify the anti-desorption compound on some of its threads before the sensor device.
 
Turck TURCK pressure sensor installation method detailed:
(1) After proper appearance, verify the frequency response of the pressure sensor under normal atmospheric pressure and normal temperature conditions.
(2) Verify the accuracy of the pressure sensor's code and the corresponding frequency response signal.
2. Determine the detailed device orientation
In order to determine the number of the pressure sensor and the detailed device orientation, it is necessary to think about the various inflation sections of the inflation net.
(1) It is necessary for the pressure sensor to be installed along the cable, preferably at the cable joint.
(2) There should be no less than 4 pressure sensors per cable, and two pressure sensors close to the telephone exchange should not be 200m apart.
(3) One device is installed at the beginning and end of each cable.
(4) One branch point should be installed for each cable. If the two branch points are close together (less than 100 m), only one can be installed.
(5) 1 cable installation method (overhead, underground) should be installed
(6) For cables without branches, because the cable program of the barrier is common, the gauge of the pressure sensor is not more than 500m, and the total number is not less than 4.
(7) In order to determine the fault point of the pressure sensor, besides the starting point device pressure sensor, from the starting point of 150~200m, other devices are of course planned. It is necessary to consider the economic and skill factors. If the device pressure sensor is local, it should not be installed.
If the dimensions of the device hole are not suitable, the high-temperature melt pressure sensor will be easily worn during the installation process, which will not only affect the sealing function of the device, but also prevent the sensor from functioning properly, and may even occur safely. Hidden dangers. Only suitable device holes can prevent thread wear (Thread Industry Specification 1/2-20UNF2B), and the device hole can generally be inspected with a device hole gauge to make proper adjustments.